Care & Assembly Guides
CARE & ASSEMBLY GUIDES
Two minutes of care, hardware that lasts
Quick instructions for mounting and looking after NAMII furniture legs, knobs, handles and wall hooks.
Furniture legs
M8 bolt mounting
- Screw the M8 bolt into the threaded insert at the top of the leg.
- Fit the plastic washer onto the bolt, resting against the top of the leg — it protects the furniture surface and helps the leg sit flush.
- Hold the leg in place and turn the bolt into the pre-drilled hole or threaded insert in the furniture base until it sits firmly.
Mounting plate
- Fix the mounting plate to the underside of the furniture with the four wood screws included — the surface needs to be flat for the plate to sit properly.
- Turn the M8 bolt into the plate's centre hole until it presses firmly against the furniture.
- Screw the leg onto the bolt's protruding end and tighten until secure.
Care
- Wipe clean with a dry or slightly damp cloth — avoid abrasive cleaners.
- Wooden legs can be treated once a year with a natural oil or wax to keep their colour.
- Protect painted or metal legs from sudden knocks, which can chip the finish.
- Lift furniture when moving it rather than dragging it, to keep the legs from working loose.
Knobs
Assembly
- Mark the screw hole on the door or drawer front.
- Push the screw through from the inside and thread it into the base of the knob.
- Tighten evenly with a screwdriver so the knob sits flush and doesn't spin.
- Gently pull the knob in different directions to check it's secure.
Care
- Wipe with a soft cloth — slightly damp if needed, then dry.
- Avoid chemical cleaners on painted or brass finishes, as they can alter the colour.
- Check the screw periodically, especially on knobs used often.
Handles
Assembly
- Measure the distance between the two screw holes (centre to centre) on the door or drawer front.
- Push both screws through from the inside.
- Thread the screws into the handle evenly on both ends, so it sits level.
- Tighten fully and check the handle doesn't twist or wobble.
Care
- Clean with a soft, dry or slightly damp cloth.
- Avoid abrasive or chemical cleaners on painted, brass or wooden finishes.
- Check the screws from time to time — frequently used handles can loosen.
Wall hooks
Assembly
- Choose a mounting spot and mark the hole centre on the wall with a pencil.
- Drill a hole to match the wall plug included with the hook.
- Push the plug into the hole until it sits flush with the wall.
- Screw into the plug and tighten the hook firmly.
- Gently pull the hook downward to check it holds securely.
Care
- The included plug is suited to concrete or brick walls — for plasterboard walls, we recommend a plug designed for that material instead.
- Wipe clean with a dry or slightly damp cloth.
- Don't exceed the hook's stated maximum load.
- For heavier items, check the screw and plug periodically to make sure they're still tight.